![]() I noticed that this issue stopped when I turned off IPv6. Happy to help diagnose this further if you need more information from me. ![]() It used to work many many many months ago I think, but some update I assume broke it. It's a complete faff, and I really hope this issue can get some development time to fix it. Last step is I now go into the VPN Client Gateway->single, open up the vpn client gateway to edit it, just click save, then apply changes and that brings the gateway online and everything is finally green. If I look at Interfaces it shows it's up and IP Address assigned. If I go back to Gateways it still shows VPN Client as offline It shows reconnecting initially and then after a refresh changes to connected and all other fields on the screen get populated. Next on the OpenVPN Connection status window I click the play button to start the VPN Client up. The VPN Connection Status page is showing Client Type VPN with a Status of blank. The Interface still shows down but the IP Address disappears The gateway for the client VPN then goes to offline So what I do next is to kill the client1 pid, 65001 in this instance If I remote into the backend and run the following command it shows the client is indeed # ps auxww | grep openvpn T17:30:56 Notice openvpn_client1 TUN/TAP device ovpnc1 exists previously, keep at T17:30:56 Error openvpn_client1 Cannot open TUN/TAP dev /dev/tun1: Device busy (errno=16) T17:30:56 Notice openvpn_client1 Exiting due to fatal error ![]() The VPN Log File has the following (snippet) which basically means it's already running in my eyes: Thirdly the VPN Connection Status page is showing Client Type VPN with a Status of failed, and subsequent restarts fail too. Secondly the Interfaces is showing the VPN Client is down, yet it has an IP allocated. Problem is after a reboot of the router, the GUI doesn't align to what is actually happening.įirstly the Gateway is showing VPN Client is up It's set to Don't pull routes or add/remove routes automatically, I just use firewall rules to push traffic via it based on some specific ports and it works well. I have an OpenVPN Client which is always running on my opnsense router. I have seen one other post in the form, which I will try and dig out with the exact same issue a while back, but obviously didn't end up reaching a root cause and resolution, however it helped me find a manual fudge to get the GUI back aligned, that is until the next reboot. I've had a problem for a while, and it's one of the reasons I switched to the opnsense development version in hope it would fix it, but it hasn't, so maybe raising awareness here might get it on the radar of someone in the know.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |